Subaru Crosstrek Owners Manual: Outgoing screen
Outgoing call screen
- Open the "Options" screen. Refer to "Phone volume settings"
- Abort the call. The screen returns to the phone (menu) screen. This is the same as pressing the on hook switch on the steering wheel.
NOTE
- Depending on the type of Bluetooth phone being connected, it may be necessary to perform additional steps on the phone.
- When you are on the outgoing call screen, the screen changes to the call screen when the other party answers the call.
The 
,
, and 
keys are disabled
on the outgoing call screen.
By Dialpad
Input the phone number manually using
the keypad displayed on the screen.
Phone (Dialpad) screen
Allow you to enter numbers from 0 to
9 and *, #, and +. To enter "+", press
and hold the ...
Receiving a call
Incoming calls
When a call is received, the incoming call
screen is displayed with a sound.
When you receive a phone call while the
cell phone is connected, the screen
changes to the incoming c ...
Other materials:
Dtc p0500 vehicle speed sensor "a" circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0500 VEHICLE SPEED SENSOR "A" CIRCUITDTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPER ...
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSTALLATIONCAUTION:• Replace the O-rings on the hose - pressure suction and discharge with new parts, and then apply compressor oil.• After replacing the compressor assembly, adjust the amount of the compressor oil. Compressor Oil ...
