LIGHTING SYSTEM > Front Turn Signal Light Bulb
INSPECTION
1. Visually check the bulb for blow out.
2. Check the bulb specification. General Description > SPECIFICATION">
3. Replace the bulb if it is found defective.
Procedure
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemPROCEDUREWhen parts related to the auto headlight beam leveler system are removed or replaced, perform the following procedures to initialize or reinitialize.NOTE:Before performing initialization or reinitialization, check the following:• ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearINSTALLATION1. Install the taper roller bearing (transfer case side) outer race.(A)Taper roller bearing (transfer case side) outer race(B)Transfer case2. Apply a coat of grease to the taper roller bearing (transfer case side) of tran ...
Switches and harness
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Switches and HarnessINSPECTIONBSD/RCTA OFF switch1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply ba ...