The immobilizer system is designed to prevent an unauthorized person from starting the engine. Only keys registered with your vehicle's immobilizer system can be used to operate your vehicle. This system, however, is not a 100% anti-theft guarantee.
For models with "keyless access with push-button start system": If you press the push-button ignition switch when carrying an unregistered access key, the switch will not turn to the "ON" position and the engine will not start.
If the engine does not start, perform the procedure described in "Starting engine" 9-18.
For models without "keyless access with push-button start system": Even if an unregistered key fits into the ignition switch and can be turned to the "START" position, the engine will automatically stop after several seconds.
If the engine does not start, pull out the key once before trying again. Refer to "Ignition switch (models without "keyless access with push-button start system")" 3-4.
CAUTION
NOTE
To protect your vehicle from theft, please pay close attention to the following security precautions:
The vehicle has a maintenance-free type immobilizer system.
Security indicator light
Refer to "Security indicator light" 3-30.
Dtc b1862 short in driver s knee airbag (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1862 SHORT IN DRIVER’S KNEE AIRBAG (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Knee airbag module harness c ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Ambient SensorINSPECTION1. Visually check the ambient sensor for dirt or damage, and clean or replace as necessary.2. Check the resistance between ambient sensor terminals.CAUTION:During inspection, be careful not to touch the sensor end in order to avoi ...
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyINSTALLATION1. Install the leak check valve assembly to the vehicle with the bolt and clip (A).Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Connect the connector to the leak check valve assembly.3. Conn ...