Subaru Crosstrek Service Manual: Heat shield cover Note
EXTERIOR/INTERIOR TRIM > Heat Shield Cover
NOTE
Refer to “EXHAUST” section for removal and installation procedure of the heat shield cover.
Fuel tank protector Note
EXTERIOR/INTERIOR TRIM > Fuel Tank ProtectorNOTERefer to “FUEL INJECTION” section for removal and installation procedure of the fuel tank protector. (Gasoline engine model) Fuel Tank P ...
Ornament Installation
EXTERIOR/INTERIOR TRIM > OrnamentINSTALLATION1. LETTER MARKAlign the end of application tape with the end of panel, then adhere the letter mark.(a)Panel - rear gate end(b)Application tape end NOTE ...
Other materials:
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSPECTION1. Check the shifter fork and fork rod for damage. Replace if it is damaged.2. Gearshift mechanismRepair or replace the gearshift mechanism if excessively worn, bent or defective in any way.3. Inspect the clearance between ...
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...
Installation
SECURITY AND LOCKS > Keyless Access CMINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type D” described in “REGISTRATION MANUAL FO ...
