Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Function settings

A SUBARU dealer can change the settings of the functions shown in the following table to meet your personal requirements. Contact the nearest SUBARU dealer for details. If your vehicle is equipped with a multi function display, the settings for some of these functions can be changed using the display. For details, refer to "Multi function display" 3-42.

Item Function Possible settings Default setting
Alarm system Alarm system Operation/Non-operation Operation
Monitoring start delay time (after closure of doors) 0 seconds/30 seconds 30 seconds
Impact sensor operation (only models with shock sensors (dealer option)) Operation/Non-operation Non-operation
Passive arming (models without "Keyless Access with Push-button Start system") Operation/Non-operation Non-operation
Dome light and map lights illumination (models with moonroof) ON/OFF OFF
Dome light illumination (models without moonroof)
Keyless Access (if equipped) Hazard warning flasher Operation/Non-operation Operation
Audible signal Operation/Non-operation Operation
Audible signal volume Level 1 to 7 Level 5
Door unlock selection function (driver's door unlock) Driver's door only/All doors Driver's door only
Door unlock selection function (rear gate unlock) Rear gate only/All doors Rear gate only
Remote keyless entry system Hazard warning flasher Operation/Non-operation Operation
Audible signal Operation/Non-operation Operation
Audible signal volume Level 1 to 7 Level 5
Key lock-in prevention Key lock-in prevention Operation/Non-operation Operation
Defogger and deicer system for models with the automatic climate control system Rear window defogger, outside mirror defogger and windshield wiper deicer Operation for 15 minutes/ Continuous operation Operation for 15 minutes
Dome light Operation of dome light/map light/ cargo area light OFF delay timer OFF/10 seconds/20 seconds/30 seconds 30 seconds
Map light for models with a moonroof
Cargo area light
Battery drainage prevention function Battery drainage prevention function Operation/Non-operation Operation
Seatbelt warning Sounds a chime while driving Operation/Non-operation Operation
Auto on/off headlights (if equipped) Sensitivity of the operation of the auto on/off headlights Low/Mid/High/Max Mid
Welcome lighting function (if equipped) Welcome lighting function (when approaching) OFF/30 seconds/60 seconds/90 seconds 30 seconds
Welcome lighting function (when exiting) OFF/30 seconds/60 seconds/90 seconds 30 seconds
Reverse gear interlocked rear wiper Reverse gear interlocked rear wiper operation Operation/Non-operation U.S.-spec. models: Non-operation Other models: Operation
One-touch lane changer Operation of the one-touch lane changer Operation/Non-operation Operation
Warning and indicator lights
Mark Name Seatbelt warning light Front passenger's seatbelt warning light SRS airbag system warning light Front pass ...

Seat, seatbelt and SRS airbags
...

Other materials:

Disassembly
GLASS/WINDOWS/MIRRORS > Outer Mirror AssemblyDISASSEMBLYCAUTION:When removing the mirror - repair, be careful not to damage the back surface of mirror - repair with a flat tip screwdriver.1. Operate the remote control mirror switch to face the mirror - repair upward.2. Disconnect the ground cable ...

General diagnostic table Inspection
DRIVE SHAFT SYSTEM > General Diagnostic TableINSPECTIONNOTE:Vibration while cruising may be caused by an unbalanced tire, improper tire inflation pressure, improper wheel alignment, etc.SymptomsPossible causeCorrective actionNoise or vibration from propeller shaft• Center bearing• Run ...

Dtc b1647 side satellite sensor bus lh lost communication
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1647 SIDE SATELLITE SENSOR BUS LH LOST COMMUNICATIONDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Side airbag sensor (L ...

© 2016-2024 Copyright www.sucross.com